Tributaries PWRI-PRO owner manual Troubleshooting, Care of Equipment, Repair of Equipment

TROUBLESHOOTING

Symptom	Possible cause	Solution
PWRI-PRO will not power up.	The PWRI-PRO is not receiving	1.	Check circuit breaker on electrical
	power		panel for power
		2.	Check that the unit has been
			connected to in wall wiring
			correctly
	Circuit breaker is tripped.	1.	Reset the circuit breaker at the
			electrical panel
		2.	If the Breaker continues to
			trip, you may be drawing too
			much current for your electrical
			service, or there is a short circuit
			in the wiring. Call an a licensed
			electrician
POWER ON LED blinks and unit	PWRI-PRO is sensing incoming	1.	Wait 5 seconds for delay and
will not power up	voltage below 90VAC or above		power on
	135VAC	2.	Have an electrician check the
			incoming voltage on that circuit.
			The PWRI-PRO will not operate
			below 90VAC or above 135VAC.
PROTECTED light goes out and	Indicates the internal surge	1.	Disconnect your electronics from
the unit stops working.	suppression is inoperative. This		the PWRI-PRO
	happens when the PWRI-PRO
	receives multiple over voltages	2.	Contact your Tributaries dealer
	and sacrifices itself to protect		for service
	your electronics.

CARE OF EQUIPMENT

GENERAL

•In general, the only cleaning necessary for your TRIBUTARIES® PWRI-PRO is a light dusting. Unplug your component from the wall outlet before cleaning it. Do not use any type of liquid or aerosol cleaners.

REPAIR OF EQUIPMENT

GENERAL

•No User Serviceable Parts Inside. If, for any reason, your TRIBUTARIES® PWRI-PRO is not operating properly, do not attempt to open case for repair. Unplug the unit and consult this owner’s manual for warranty and service information.

6

ENGLISH