nEglish

Troubleshooting

Symptom

Possible cause

Solution

 

 

 

 

T200 will not power up.

The T200 is not receiving

1.

Check that the unit is plugged in.

 

power.

2.

Check the outlet for power.

 

 

 

 

 

 

 

Circuit breaker is tripped.

1.

Reset the circuit breaker on the

 

 

 

front panel.

 

 

2.

If the Breaker continues to trip,

 

 

 

try moving one or more units to

 

 

 

another Power Manager, you may

 

 

 

be drawing too much current.

 

 

 

 

Triggers will not power up

There is no power to the

1.

Check the trigger input cable. It

unit.

trigger.

 

must be connected to the trigger

 

 

 

input on the rear panel.

 

 

2.

Ensure the trigger cable you are

 

 

 

using is terminated with a 3.5mm

 

 

 

mono plug.

 

 

3.

Trigger voltage is incorrect (below

 

 

 

3 volts or over 30 volts). Check

 

 

 

the trigger source to be sure the

 

 

 

signal is between 3-30 volts DC.

 

 

 

 

Protected light goes out.

Indicates the internal surge

1.

Do not operate the T200 if the

 

protection is inoperative.

 

PROTECTED light is out.

 

This happens when the T200

 

 

 

receives multiple over voltage

2.

Disconnect your electronics from

 

surges and sacrifices itself to

 

the T200.

 

protect your electronics.

3.

Contact your Tributaries dealer

 

 

 

 

 

for service.

 

 

 

 

The Polarity Fault light

This indicates that the wall

1.

Do not operate the T200 with

turns on.

outlet the T200 is plugged into

 

the polarity FAULT light

 

has it’s polarity inverted.

 

illuminated.

 

 

2.

Call an electrician to have the line

 

 

 

repaired.

 

 

 

 

There is no picture on your TV.

Signal cables are not connected

1.

Check that the cables are

 

correctly.

 

properly connected to the input

 

 

 

and output of the DSS/CATV

 

 

 

connectors on the back of the

 

 

 

T200.

 

 

2.

Check all connections from each

 

 

 

source to the TV to ensure they

 

 

 

are all properly connected.

 

 

 

 

There is a audible “thump”,

While annoying, this is not

1.

To minimize or eliminate

“click” or “pop” coming from

an unusual occurrence. It can

 

“thumps”, “clicks” or “pops”,

your speakers during power

happen when a preamplifier or

 

connect the power amplifier(s) or

up.

power amp is being turned on.

 

receiver to the delayed outlets.

 

 

 

 

9

Page 10
Image 10
Tributaries T200 owner manual NEglish Troubleshooting, Symptom Possible cause Solution