FARGO electronic HDPii manual Troubleshooting with the LCD Error Message Table

RESTRICTED USE ONLY Fargo Electronics, Inc.

Troubleshooting with the LCD Error Message Table (continued)

LCD Error Message	Cause	Solution
Mag Encoder Paused	The Magnetic Encoder is in
(PC Error Message	a pause state.
No. 143)
Mag Encoder Startup	A problem was detected	Reset the Printer and try
Error	during Printer start-up.	again.
(PC Error Message		If this problem persists, call for
No. 63 and 141)		technical assistance.
Mag Verify Error	Print could not verify MAG	Check the Cards and click on
(PC Error Message	write.	Cancel Print.
	OR
No. 30)
	The magnetic stripe was not
	encoded properly.
Multiple Feed	Multiple cards were fed into	Remove all cards and try
	the Printer.	again.
(PC Error Message
No. 70)

HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 5-12