FARGO electronic HDPii manual To prevent equipment or media damage, refer to

RESTRICTED USE ONLY Fargo Electronics, Inc.

Section 4: Accessory Procedures

Safety Messages (review carefully)

Symbol	Critical Instructions for Safety purposes
Danger:	Failure to follow these installation guidelines can result in
	death or serious injury.
	Information that raises potential safety issues is indicated by a
	warning symbol (as shown to the left).
	• To prevent personal injury, refer to the following safety
	messages before performing an operation preceded by this
	symbol.
	• To prevent personal injury, always remove the power cord
	prior to performing repair procedures, unless otherwise
	specified.
Caution:	This device is electrostatically sensitive. It may be damaged if
	exposed to static electricity discharges.
	Information that raises potential electrostatic safety issues is
	indicated by a warning symbol (as shown to the left).
	• To prevent equipment or media damage, refer to the
	following safety messages before performing an operation
	preceded by this symbol.
	• To prevent equipment or media damage, observe all
	established Electrostatic Discharge (ESD) procedures while
	handling cables in or near the Circuit Board and Printhead
	Assemblies.
	• To prevent equipment or media damage, always wear an
	appropriate personal grounding device (e.g., a high quality wrist
	strap grounded to avoid potential damage).
	• To prevent equipment or media damage, always remove the
	Ribbon and Cards from the Printer before making any repairs,
	unless otherwise specified.
	• To prevent equipment or media damage, take jewelry off of
	fingers and hands, as well as thoroughly clean hands to remove
	oil and debris before working on the Printer.

HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 4-1