Operating sequence
1. Check the filters
Ensure they are clean and properly positioned (see "Maintenance and cleaning").
2. Press the MAINS ON push button
The MAINS ON indicator light will come on.
3. Check that there is rinse aid and salt
The salt indicator light will illuminate if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5.Ensure that the spray arms can rotate freely
6.Measure out detergent
Add the required amount of detergent into the dispenser according to the recommended quantity given in the Washing programmes chart.
Close the detergent dispenser lid.
7.Close the dishwasher door
8.Setting and starting the programme
Press the push button corresponding to the required programme: the indicator light corresponding to the programme illuminates and the phase indicator lights for that programme start flashing.
The start of the programme will occur after about 6 seconds from the last pressure of a programme push button, in this time it is possible to change programme simply pressing the push button of another programme. Once the programme has started the phase indicator lights will turn off except for the phase under way.
It is possible to interrupt the programme by:
●opening the door
●pressing the MAINS ON push button (in this case all the indicator lights turn off)
Close the door again or press the MAINS ON push button, the programme will start from the point in which it was interrupted.
9. To cancel a programme in progress
A programme in progress can be cancelled at any time. Press for about 3 seconds the push button of the running programme until all indicator lights are off.
Only the MAINS ON indicator light will remain on once the programme has been cancelled.
It is now possible to select a new washing programme.
10. At the end of the washing programme
The dishwasher will automatically stop and the phase indicator light end of programme will come on.
The indicator light of the programme just ended will remain on.
The dishwasher has finished the programme only when
the end of programme ( END ) indicator light is illuminated. If you do not wait for the end of the programme it will not
be possible to start a new programme if first you do not cancel the previous.
(For instructions on how to cancel a programme see point 9)
Switch off the dishwasher by pressing the MAINS ON push button and open the door.
Wait a few minutes before removing the dishes; in this way they will be cooler and drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.
Important!
In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.
Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape.
When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.
10
