To select a different level ensure that the dishwasher is off and then proceed as follows:
1. Press | RINSE & HOLD | and | INTENSIVE | programme push | ||
buttons simultaneously. |
|
|
|
| ||
2. While keeping the programme push buttons |
| RINSE & | ||||
HOLD | and | INTENSIVE pressed switch on the dishwasher | ||||
by pressing the |
| MAINS ON |
| push button. |
| |
The | MAINS ON | indicator light comes on. |
| |||
At the same time, the indicator lights of the | RINSE & HOLD | |||||
and | INTENSIVE push buttons start flashing. |
| ||||
3. Press the | RINSE & HOLD |
| push button, the indicator light of |
Filling with salt
Only use salt specifically designed for use in dishwashers.
All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener.
Only fill with salt just before starting one of the washing programmes.
This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for any period of time, which may cause corrosion.
To fill:
1.To fill with salt, unscrew the cap of the salt container.
|
|
|
|
|
|
|
|
|
| SO527 |
| ||
the | INTENSIVE push button turns off, while the indicator | |||||
light | of the | RINSE & HOLD | push button remains fixed for | |||
about | 5 | seconds, after this it starts flashing indicating the | ||||
current | level of the water softener. |
|
The current level is indicated by the number of flashes
2.Pour 1 litre of water inside the container (this is necessary only
before filling with salt for the first time).
3.Using the funnel provided, pour in the salt until the container is full.
Do not worry if water over flows from the unit when filling with salt, this is quite normal.
4.Replace the cap making
sure that there is no trace of salt on the screw thread or on the gasket.
SALET |
SAL |
SALZ |
SEL |
SR06 |
SO528
made by the |
| RINSE & HOLD | indicator light, that alternates | |
5 | seconds off with a number of flashes, this for about 60 | |||
seconds. |
|
|
| |
Example: |
|
|
| |
1 flash |
| = level 1 |
| |
2 | flashes | = | level 2 |
|
3 | flashes | = | level 3 |
|
4 | flashes | = | level 4 |
|
5 | flashes | = | level 5 |
|
4. To change the level, press the |
| RINSE & HOLD |
programme push button. Each time the push button is | ||
pressed the level changes. |
|
|
Example: |
|
|
if the current level is 3, by pressing the | RINSE & HOLD | |
programme push button once, level 4 is selected. | ||
if the current level is 5, by pressing the | RINSE & HOLD | |
programme push button once, level 1 is selected. | ||
The RINSE & HOLD | indicator light remains off for about 5 |
seconds after which it starts flashing indicating the new level selected.
5.To memorise the new level, switch off the dishwasher by
pressing the | MAINS ON | push button. |
5.Screw on the cap tightly.
The salt container will require topping up periodically.
You are reminded of this by the salt indicator light on the control panel which comes on when the salt has finished.
The salt indicator light on the control panel can remain illuminated for
on. If you are using salts that take longer to dissolve then this can take longer. The function of the machine is not affected.
5