Tricity Bendix SE210/1W Something not Working, Hotplate is not giving satisfactory Check Results

SOMETHING NOT WORKING

If the appliance is not working correctly, please carry out the following checks, before contacting your local Service Force Service Centre.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

Symptoms			Solutions
The hob hotplate does not heat up	Check:
	-	that the unit is connected and the electrical
		supply is switched on
	-	the mains fuse has not blown
	-	the correct control knob has been turned.
The hotplate is not giving satisfactory	Check:
results	-	the hotplate is clean and dry
	-	the	pan is the correct size for the hotplate
	-	the	pan has a flat bottom
	-	the setting is correct for the type of cooking.
The oven does not come on	Check:
	-	check if a cooking function/temperature has
		been selected correctly
	-	the socket switch or the switch from the
		mains supply to the cooker is ON.
It takes too long to finish the dishes, or	Check:
they are cooked too fast	-	the temperature may need adjusting
Steam and condensation settle on the	-	refer to the contents of this booklet,
food and the oven cavity		especially to the chapter “Using the Oven”.
	-	Leave dishes inside the oven no longer than
		15-20 minutes after the cooking is completed.

If after these checks, the appliance still does not operate correctly, contact your local Service Force Centre. When you contact the Service Force Centre you will need to give the following details:

1.Your name, address and postcode.

2.Your telephone number

3.Clear and concise details of the fault

4.The model and serial number of the appliance (found on the rating plate*)

5.The purchase date

* The rating plate can be found on the lower left hand corner of the front frame of the cavity.

Please note that valid purchase receipt or guarantee documentation is required for in- guarantee service calls.

14