Tricity Bendix SE 210 manual Important Safety Requirements, Location, Levelling

IMPORTANT SAFETY REQUIREMENTS

Important

This cooker must be installed in accordance with the IEE Wiring Regulations (Current Edition). Detailed recommendations are contained in the following British Standards Codes Of Practice:

B.S. 6172/ B.S. 5440, Par.2 and B.S. 6891 Current Editions.

LOCATION

The appliance must not be installed in a bed-sitting room of volume less than 20m3 or in a bathroom or shower room. It is essential that the appliance is positioned as in the enclosed figure i.e. shelves, wall cabinets and cooker hoods must be fitted a minimum of 690mm directly above the top of hotplate and 400mm above the hotplate when fitted in line with the outside of the appliance. If the units are intended to be fitted adjacent to the appliance but less than 400mm above the hotplate, then a minimum space of 100mm must be maintained between the sides of the unit and the appliance (see fig).

If fitted next to or between two base units a minimum space of 1mm must be left between each unit and the sides of the appliance. The levelling feet fitted to the appliance will achieve a nominal height to hotplate of 900mm+10mm.

The appliance must be installed in accordance with EN 1116-1995, regarding the depth of the superior furniture.

690

400
C	G
1
2
34
5678

max 400

min 600

min 570

690
100	less
	4
G
78

Levelling

Fix the support with two legs with the washer and nuts, delivered with the cooker, see the figure.

•Unscrew the legs as far as possible (approx. 16mm from fully screwed in).

•Place the plinth (pos.3) so that the springs (pos.2) reach the threaded area of the legs and the clamp of the plinth (pos.4) is in front of the holes (pos.5) on the under side of the structure.

•Push the plinth towards the appliance with both hands until the springs fasten on the legs and the clamps go into the corresponding holes.

•Adjust the legs as necessary.

4

5

3

2

1

18