Installation
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Levelling
Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.
Water supply connections
This dishwasher must be plumbed into a cold water supply. |
| |
The water pressure must be within the limits given in the |
| |
"Technical specifications" | (Instruction Book - Part 2) | . |
Your local Water Authority will advise you on the average mains pressure in your area.
The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation. Do not use, for connection, old hoses which have been used in another appliance.
The locknut must be correctly fitted to avoid water leaks.
Avoid bends or kinks in the hose which could prevent or slow down the water supply.
If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose.
This will prevent deposits of sand or rust clogging the inlet hose.
Water outlet hose connection
The end of the drain hose can be connected in the following ways:
1.To the sink outlet spigot, securing it if necessary with a clip.
IN06 |
IN07 |
Attention!
Our appliances are supplied with a with a security device to protect against the return of dirty water back into the machine.
If the spigot of your sink has a "no return valve" incorporated this can prevent the correct
draining of your dishwasher. We advise you therefore to remove it.
2.Hooked over the edge of the sink using the special
curved plastic guide ( | if provided | ). |
3.To a stand pipe provided with
|
| 1 | 2 | 3 |
Ø | 21 |
|
| 4 cm |
Ø | 18 |
| min | |
|
|
| ||
|
|
|
| |
|
|
| max 100 cm | min 30 cm max 100 cm |
CS09 |
|
|
|
|
10
