The tumble dryer must be installed in a clean place, where dirt does not build up.
Door reversal
P0281 |
Important |
Make sure there are no obstructing items or material near the
etc.).
To make it easier to load or unload the laundry the door can be reversed.
This operation must be carried out by qualified personnel.
Operate as follows:
- Remove the door by unscrewing the two screws (1) |
fastening the hinge to the cabinet (Fig. A). |
- Remove the safety catch (2) by pressing it down- |
wards (Fig. A) and refit it on the opposite side of the |
door. |
- Using a screwdriver, remove screws (3), plastic |
plate (4) and plug (5), see picture A. Take care not |
the damage the cabinet. |
When operating the tumble dryer, the room tempera- ture must not exceed 35°C, as it may affect the perfor- mance of the appliance.
To save energy, the room temperature should not be lower than +15°C.
Refit them on the opposite side (Fig. B) |
- Refit the door by screwing in the two screws (1) |
which fasten the door to the cabinet (Fig. B). |
Levelling |
P0046 |
Level the tumble dryer into place by screwing or unscrewing the front feet as required.
Accurate levelling will keep vibration and noise to a minimum when the dryer is in use.
2
P0883
5
13
4
A
P0884
5
4 
3 1
2
B
5
