Eliminator SE400E & SE800E
Section II – Installation
1.INSTALLATION CAUTION:
ELECTRONIC AIR CLEANERS
CANNOT BE USED IN AREAS WHERE COMBUSTIBLE GASES OR VAPORS ARE PRESENT.
MECHANICAL
The unit has been designed so that it can fit either surface mounted onto the ceiling,
SUSPENDED CEILING INSTALLATION
To hang the unit into a suspended ceiling, proceed as follows:
a)Unpack the unit, open filter access door and remove prefilter and cell (see filter removal in section 2).
b)Install
c)Install trim as shown in sketch A.
d)Select and remove a ceiling tile near the center of the area to be cleaned by the unit.
e)Attach a length of safety chain to each of the four eyebolts or fit threaded rod. Fasten securely.
f)Lift unit into place and support unit while securing to permanent ceiling, ceiling joists, etc. See sketch A.
CAUTION:
IT IS THE RESPONSIBILITY OF THE INSTALLER TO ENSURE ADEQUATE MOUNTING COMPONENTS ARE USED.
DO NOT ALLOW WEIGHT OF UNIT TO
REST ON SUSPENDED CEILING
SUPPORT RAILS.
g)Make electrical connections as detailed in next section.
h)
i)Close access door and unit is ready for operation.
SOLID CEILNG MOUNTING
To mount the unit to a solid ceiling, proceed as follows:
a)Unpack the unit, open filter access door and remove prefilter and cell (see filter removal in section 2).
b)Select a location near the center of the area to be cleaned. lf you are fitting to wooden ceiling joists, locate the position of joists.
c)Using the template provided, drill four holes into the ceiling and fit four 5/16 lag screws in the joists.
d)Lift the unit to where the large end of the keyhole slots in the top of the cabinet fit over the screw heads. Slide the unit so that the narrow ends of the mounting slots are located under the screw heads. Tighten the screws fully home.
e)Install the lockdown location screw as shown on template.
f)Make electrical connections as detailed in next section.
g)
h)Close access door and unit is ready for operation.
WALL MOUNTED (SE400E Only)
Filter removal will be simpler if the unit is positioned with the access door hinge in a vertical plane. Locate the wall studs and follow the mounting instructions for SOLID CEILING MOUNTING.
ELECTRICAL:WARNING:
THIS APPLIANCE MUST BE
ELECTRICALLY GROUNDED.
NOTE: This unit is designed to be permanently connected to fixed wiring. Installation must comply with all applicable electrical codes.
5