Trion T5200 I. Specifications, Ii. Preparation For Installation, New Unit Inspection, Operation

I. SPECIFICATIONS

POWER REQUIREMENTS

Model		Voltage	HP	AMPS (Max)
T5200B		230V, 60 HZ, 3 PH.	2	6.8
T5200B		230V, 60 HZ, 3 PH.	3	9.7
T5200C		460V, 60 HZ, 3 PH.	2	3.4
T5200C		460V, 60 HZ, 3 PH.	3	4.9
T5200D		575V, 60 HZ, 3 PH.	2	3.2
T5200N		208V, 60 HZ, 3 PH.	2	6.8
Note:
Ionizer Voltage:	6 KVDC
Collector Voltage:	12 KVDC

Motor: (where applicable) Ball bearing, Totally enclosed, Fan Cooled.

II. PREPARATION FOR INSTALLATION

This manual should be carefully read before starting the preparation and installation of the air cleaner.

The installation should conform to all local ordinances associated with building codes and electrical codes required for the unit. Authorities having jurisdiction should be consulted before installation is made. If there are no local codes, the installation should conform to the National Electrical Code.

SAFETY NOTE:

Factory designed access to all electrically charged high voltage components contain electrical interlocks for the safety of operating personnel. Any additional access that may be provided in the system, where there is access to high voltage, must be equipped with such interlocks. Interlocks are readily available from the factory.

The 575V, 3 Phase unit does not have internal motor overload protection. The installer must provide overload protection in accordance with National Electrical Code, Canadian Electrical Code, Part 1 or other applicable electrical codes.

For maximum air cleaning efficiency, your air cleaner should be located as specified by your Trion representative.

The unit can be either wall-mounted or chain-hung. Eyebolts can be supplied by Trion.

NEW UNIT INSPECTION

Immediately, upon receiving the unit, carefully examine the package for damage during transit. If the unit is damaged, contact the last carrier for claim filing and contact your Trion representative.

While unpacking the unit, look for concealed shipping damage. If there is damage, it should be reported to the last carrier for claim filing.

OPERATION

What is your Electronic Air Cleaner?

Your air cleaner is a high efficiency contaminant collector designed to remove up to 95% of the dust, smoke, liquid aerosol and other pollutants from the air passing through it.

HOW IT OPERATES

Polluted air is drawn into the unit by the belt driven blower on the T5200 unit. The T1001 and T2002 units require an external air handler to move the air.

After passing through a pre-filter, the particles in the air are given an electrical charge supplied by the power supply. As the particles enter the collector cells, these charged particles are attracted to and collected on grounded collecting plates.

Typical Electronic Cell Operation

UNIT OPERATION

Control Switch (A): The control switch is located on the cell access door. It controls the operation of the power pack and the belt driven blower. The control switch should be in the “OFF” position when the cell access door is open for maintenance of the unit.

Indicating Light (B): The light located adjacent to the control switch is an indicator of the performance of your electronic air cleaner. When the control switch is “ON”, the blower should operate and the indicator light should glow. If the light does not glow or if it continually flickers

3