Procedure

Battery Replacement

Battery replacement should be performed only by authorized service personnel using the same num- ber and type of batteries (sealed Lead-Acid). Under normal conditions, the original batteries in your UPS will last many years. See Safety section before replacing batteries. The batteries are designed for hot-swap replacement (i.e. leaving the UPS in ON mode), but some qualified service personnel may wish to put the UPS in the OFF mode and disconnect equipment before proceeding.

Manual del propietario

SmartPro® 3U Rackmount

1Remove Front Panel and Battery Holding Plate

2Disconnect Batteries

3Remove/Dispose of Batteries

4Add Batteries

5Connect Batteries

Attach connectors: black-to-black and red-to-red.

6Replace Front Panel

WARNING!

Batteries can present a risk of electrical shock and burn

from high short-circuit current resulting in serious

injury or death. Battery terminals are in close proximity to UPS cabinet and special care must be taken to avoid shorting the batteries including not touching metal cabinet and battery terminals simultaneously.

	SMARTPRO UPS
1	6
1	6


2	5


3	4

(5000VA)

Sistemas de UPS Inteligentes e Interactivos en Línea

• 230V Entrada/Salida

• Opciones de Operación Extendidas No conveniente para los usos móviles.

Instrucciones de seguridad importantes	14


Montaje	15

Instalación rápida	16

Instalación opcional	17

Operación básica	19


Almacenamiento y servicio	23


Reemplazo de batería	24


English	1

Français	25

The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.

Regulatory Compliance Identification Numbers

For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number. The series number can be found on the product nameplate label, along with all required approval markings and information. When requesting compliance information for this product, always refer to the series number. The series number should not be confused with the marking name or model number of the product.

This product designed and engineered in the USA.

Note on Labeling

Two symbols are used on the label.

V~ : AC Voltage

V : DC Voltage

Póññêèé

1111 W. 35th Street Chicago, IL 60609 USA

Soporte al cliente: (773) 869-1234 • www.tripplite.com

Tripp Lite 3U Rackmount Procedure, Sistemas de UPS Inteligentes e Interactivos en Línea

Models: 3U Rackmount