Owner’s Manual
PDU Rackmount Power Strips
Designed for Mounting in 19 in. Racks
Español: p. 3 • Français: p. 5
IMPORTANT SAFETY INSTRUCTIONS. This manual contains information concerning the proper installation and use ofTripp Lite’s Rackmount Power Strips.
SAVE THESE INSTRUCTIONS.
Do not connect your power strip to an ungrounded outlet. Do not use it with extension cords or adapters that eliminate its connection to ground. Your power strip is designed for indoor use only. Install it away from heat emitting devices such as radiators and heat registers. Do not install where excessive moisture or other conductive contaminants are present. Never install electrical wiring during a lightning storm.
The power requirement of each device connected to an outlet of your power strip must not exceed the Outlet Power Rating of your power strip (see Specifications). The total power requirements of all devices connected to your power strip must not exceed the Maximum Load Rating of your power strip (see Specifications).
1U Rackmount Installation
To Mount Unit in Rack: Put four
0U Rackmount Installation
1.Reorient Mounting Ears: Unscrew the screws (A) holding the unit’s mounting ears (B) to the sides of the unit. Use the screws from Step 1 (A) to reattach the mounting ears
(B)to the unit as shown. Use only the manufacturer- supplied screws or their equivalent
2.Mount Unit on Outside of Rack Rails: Put four user- supplied screws (C) or similar mounting hardware through the unit’s mounting ears (B) and into the side of the rack as shown. The user must determine the fitness of the
Wallmount/Under Counter Installation
Reorient the unit’s mounting ears as per the 0U Rackmount Installation above, then put four
1U Rackmount Installation |
