Installation and Operation
1Connect the HDMI source to the HDMI input on the local transmitter unit.
2Connect the TMDS RJ45 port on the local transmitter to the TMDS RJ45 port on the remote receiver using Cat5e/6 cable.
Note: See the installation diagrams for maximum extension distance at 1080p (24 Hz) / 1080i (60 Hz) video resolutions.
3Connect the DDC RJ45 port on the local transmitter to the DDC RJ45 port on the remote receiver using Cat5e/6 cable.
Note: See the installation diagrams for maximum extension distance at 1080p (24 Hz) / 1080i (60 Hz) video resolutions.
4Connect the HDMI output on the remote receiver to the HDMI monitor.
5Connect the external power supply to the remote receiver, and then plug it into a Tripp Lite Surge Suppressor, Uninterruptible Power Supply (UPS), or Power Distribution Unit (PDU). The Green LED on the remote unit will illuminate to indicate that power is being received.
6Turn on the power to the HDMI source.
Note: The Red LED on the Remote Receiver unit will illuminate only if a working signal is NOT being received. The unit is functioning properly when this LED is not illuminated.
3
1/4/2012 11:49:36 AM |
