Tripp Lite HCRK-1 Connection / Start-Up continued, Turn the Power Supply Module’s Outlets ON

Connection / Start-Up continued

5Turn the Power Supply Module’s Outlets ON

Press and hold the “Power” button* for one second. The alarm will beep once briefly after one second has passed. Release the button. The “Power” LED* will illuminate to indicate that the Power Supply Module’s outlets are ON. The Battery Charge LED Meter* will indicate the approximate charge level of the connected Battery Module.

* Located on the Remote User Interface (RUI).

5

6 Plug Your AC Equipment into
the Power Supply Module’s
Outlets
The Power Supply Module provides filtered,
pure sine-wave 120V AC power for a variety of
equipment—computers, monitors, diagnostic
devices, scanners and more. You will overload
the Power Supply Module if the total VA ratings
for all the equipment you connect exceeds	6
200VA (the Power Supply Module’s continuous
output capacity).*

*To find your equipment’s VA ratings, look on their nameplates. If the equipment is listed in amps, multiply the number of amps by 120 to determine VA. (Example: 1 amp x 120 = 120 VA).

7	OPTIONAL—Install PowerAlert
	Data-Saving Software
	This connection is optional. The Power
	Supply Module and Battery Module will
	function properly without this connection.
	Using the included cable*, connect the
	Power Supply Module’s USB port to the
	USB port on any laptop or desktop
	computer mounted on the mobile cart.	7
	Insert the included PowerAlert CD and load
	the version of PowerAlert appropriate for
	the computer’s operating system. Follow
	the setup and configuration screens for your
	specific application.

*If desired, you can substitute standard USB cable in place of the included cable.

6