Tripp Lite OMNIVS800 Quick Installation optional, Phone Line/Network Line Surge, Suppression

Quick Installation optional

These connections are optional. The UPS will function properly without these connections.

1	Phone Line/Network Line Surge
	Suppression
	The UPS has jacks which protect against surges over a
	phone line or network data line.
	Using telephone cords or network data cables as
	appropriate, connect the wall jack to the UPS jack marked
	“IN.” Connect equipment to the UPS jack marked “OUT.”
	Make sure the equipment connected to the UPS jacks is
	also protected against surges on the AC line. NOTE:	1 OMNIVS1500XL
	Tel/DSL/Ethernet (RJ-45) jacks not compatible with PoE
	(Power over Ethernet) applications.

2 USB Communications

Use a USB cable to connect the computer’s USB port to the USB port of the UPS. Download the PowerAlert UPS monitoring software program appropriate for the computer’s operating system from www.tripplite.com/software/ and install it.

	External Battery Connection	2	OMNIVS1500XL
	(OMNIVS1500XL only)
3
	All UPS models come with a robust internal battery system;
	select models feature connectors that accept an optional
	external battery pack (sold separately from Tripp Lite) to
	provide additional runtime. Adding an external battery will
	increase recharge time as well as runtime. See battery pack
	owner’s manual for complete installation instructions. Make
	sure cables are fully inserted into their connectors. Small
	sparks may result during battery connection; this is normal.
	Do not connect or disconnect battery pack when the UPS is	3 OMNIVS1500XL
	running on battery power.

Basic Operation

Buttons

Switch the Operating Mode: While the UPS is plugged into a live AC outlet,

ON/OFF Button: press the ON/OFF button and hold it until the UPS beeps (about 2 seconds) to toggle between ON and OFF.

•ON Mode: ENABLES battery backup. UPS Conditions: The UPS charges the

battery and supplies power to the outlets while receiving utility line power. The “ ” indicator light will illuminate. If utility power fails, the UPS provides power from battery.

Cold-Start: Cold start the UPS to use it as a stand-alone power source when utility power is not present (if the UPS battery is charged). To cold start the UPS, press and hold the ON/OFF button until the UPS beeps (about 2 seconds), then release it. The “ ” indicator will illuminate and AC power inverted from stored battery power will be provided to the outlets.

4