Tripp Lite RV2012UL owner manual Insulator Drip Shield Installation Instructions, PowerVerter

Insulator Drip Shield Installation Instructions

WARNING! The Insulator Drip Shield is required for installation on your Tripp Lite DC-to-AC Inverter/Charger when it is used in marine applications (e.g. aboard watercraft). Failure to install it as described below may lead to personal injury and/or damage to the Inverter/Charger and connected systems.

Installation

1Locate and remove the four hex screws on the top panel of your

Inverter/Charger as shown.

1

2Place the Insulator Drip Shield on the top panel of the Inverter/

Charger. Line up the holes in the shield with the exposed screw holes on the top panel.

2

3Using the hex screws, secure the Insulator Drip Shield to the top

panel of the Inverter/Charger.

3

						Solutions
NEW!						Applications!	Owner's Manual Addendum
					Power
			Mobile
	Best		&	Marine
The		RV
forBoth						PowerVerter®
	RV1012UL & RV2012UL
			RV & Marine DC-to-AC					Marine	1111 W. 35th Street, Chicago, IL 60609 USA
				Inverter/Chargers					Customer Support: (773) 869-1234
									www.tripplite.com

Listed

Power Inverter

The new RV1012UL and RV2012UL are the most rugged, reliable Inverter/Chargers available— ideal for both RV and marine applications. RVs and boats often experience severe shocks, while driving over potholes and rough road surfaces or while navigating in choppy seas. RVs and boats also experience constant vibration, from surface friction, drive engines and on-board generators. The RV1012UL and RV2012UL are engineered specifically to meet the challenges of demanding RV and marine environments—and are UL-tested to perform reliably under the most extreme shock and vibration conditions.

The new RV1012UL and RV2012UL include all the features and functions of previous versions of the RV1012UL and RV2012UL listed in the enclosed owner's manual, with the following exceptions:

•Ten-Point Mounting Flanges—provide up to 10 connecting points for tight adhesion to the mounting surface

•Splash/Condensation Drip Shield—Added protection for control panel against potentially disruptive moisture in marine environments (required for marine applications)

•Battery Recharge Rate LED Meter—indicates approximate recharge rate of connected RV or marine batteries

•UL 458 (Shock/Vibration) Tested*—performs reliably in the most demanding RV and marine environments under the most extreme shock and vibration conditions (caused by potholes, rough roads, high seas, surface friction or engine/generator vibration)

* Tested for conformity to UL458 and UL458 Marine Supplement—for both RV and marine applications.

ATTENTION: For Marine Applications, See Inside.

200412030 93-2431