SR14
Dual Fan Kit
Please read these instructions carefully and follow the installation steps in sequence.
Tools Required
Phillips head screwdriver
CLIP NUT INSTALLATION
Clip nuts provide mounting points on 19" rack mount equipment rails.
Clip nuts have a front or screw side. Consider which way it should face for ease of access to the screwhead during component installation. (see figure 1)
To remove a clip nut from a rail, insert a flat blade screwdriver or knife under the tab on the front and pry up, freeing the retainer ring from the rail.
1. Select the location at which the fan panel will be installed in the enclosure.
2. Install one clip nut into the top hole at the selected position and then install another one six holes down. (see figure 2)
3. Measure from the bottom of the vertical rail to the top clip nut. Assemble the clip nuts onto the opposite rail at the measured height.
4. Assemble the Fan Panel to the rails with the
Rail
Figure 1
5” Fan Panel
Use this hole
Clip nuts
Use this hole
Rail
Figure 2
Rails
Clip nuts
Cord 
.5”
.625”
.625”
.5”
.625”
.625”
.5”
.625”
.625”
.5”
Manual Part | Figure 3 |
| |
07/09/02 rev. A | 1 |
