TRIPP LITE

1111 W. 35th Street

Chicago, IL 60609 USA

(773)869-1234

www.tripplite.com

TRIPP LITE

POWER STRIPS

(Standard Models)

Français : p. 2; Español: p. 3

Your Power Strip is designed to provide convenient multiple AC outlets. NOTE: The Power Strip DOES NOT provide your connected equipment with surge or line noise protection.

ELECTRICAL CONNECTION

Plug your Power Strip into a standard, grounded electrical outlet. DO NOT plug your Power Strip into 2-wire extension cords or adapters. DO NOT drill into or open any part of the housing. There are no user-serviceable parts inside.

EQUIPMENT CONNECTION

Plug your equipment into the Power Strip's AC receptacles. DO NOT plug in equipment that draws more total amps than your Power Strip's amperage rating (see label on Power Strip for amperage rating), or you will trip the circuit breaker. If the circuit breaker trips, remove overload and depress breaker to reset. Leave enough clearance at the end of the Power Strip to allow the circuit breaker to operate normally.

Note: Select models with a power switch feature a protective switch cover. To access the switch, simply flip open the attached cover.

HORIZONTAL MOUNTING

All standard Power Strip models feature clips for mounting to a variety of surfaces.

1.Mark a straight, horizontal line where you want to mount the Power Strip. At each end of the line, mark where the edges of the Power Strip will be located.

2.Using the supplied screws (or other ap- propriate hardware) mount one clip at each end of the line spaced 1 in (2.5 cm) from your outside marks. If your Power Strip is longer than 48 in (120 cm), mount a third clip mid- way between the first two clips.

3.Place the Power Strip on bottom edge of the mounting clips and snap into place.

1 in.

1 in.

Steps 1 & 2
Step 3

Copyright 2001 Tripp Lite. All rights reserved.

C UL US

 

 

 

 

 

 

Page 1
Image 1
Tripp Lite Surge Protector user service Tripp Lite Power Strips, Standard Models, Electrical Connection, Steps 1