WARRANTY |
|
| for | Lite |
|
| |||
|
|
| today | .com/warranty |
|
| |||
REGISTRATION: |
| Tripp |
| Mounting Instructions | |||||
| online |
| FREE |
| |||||
|
|
|
| ||||||
|
| win .tripplite |
|
|
| ||||
register | a |
|
|
|
|
|
| ||
www |
|
|
|
|
|
| |||
| to |
|
|
|
|
|
|
|
|
chance — |
|
|
|
| Collapsible |
| |||
product |
|
|
|
|
|
| |||
|
| Wallmount Bracket | 1111 W. 35th Street | ||||||
|
|
|
|
|
|
| Model: UPSWM | Chicago, IL 60609 USA | |
|
|
|
|
|
|
| Customer Support: (773) | ||
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Not suitable for mobile applications. | www.tripplite.com |
| B |
| A |
| C |
| D |
B | E |
| C |
Wallmount
Instructions:
The UPSWM is shipped in its collapsible position and includes two mounting braces. Open the mounting bracket, hold the bracket level against the intended mounting surface and mark the locations of the mounting holes . Drill 1/8” guide holes in these locations. Place the included washers around the included screws, then drive the screws through the mounting holes and into the guide holes. Install the mounting braces by putting the two buttons on each brace through the holes on the side of the unit .
CAUTION: The hardware (screws and washers) included with the bracket is only intended for use with plywood surfaces. To mount your bracket on a different surface, you must determine a safe mounting procedure and obtain proper hardware.
Mounting a
UPS System or
Battery Pack:
CAUTION: Before mounting a UPS, make sure the UPS is OFF and unplugged. Before mounting a BP36V27 battery pack, make sure that the battery pack is disconnected from your UPS system. The UPS or battery pack is extremely heavy. Take care to avoid injury while lifting.
Place the UPS or battery pack in the mounting tray. The feet of a UPS should press against the rear ridge and fit around the center ridge while the front of the UPS presses against the front ridge . The base of a battery pack should fit between the rear and center ridges, with its cords facing the wall.
Next, pass the safety strap around the UPS or battery pack and through the mounting tray as shown. The safety strap should pass through the tray’s outer strap holes for a UPS or through the tray’s inner strap holes for a battery pack. Fully tighten the safety strap and fasten the velcro end.
Mounting an
SNMP Solo (optional):
Affix one of the
Copyright © 2007. All rights reserved. The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.