Panasonic KX-TG7301NZ, KX-TG7302NZ Battery charge

Preparation

14

1Firmly press the notch on the

handset cover and slide it in the

direction of the arrow.

2Insert the batteries negative (T)

end first. Close the handset cover.

Important:

LIf the handset does not automatically

turn on after installing/replacing

batteries, press {ih} for about 1

second, or place the handset on the

base unit or charger.

Note:

LWhen replacing batteries, remove the

old batteries.

Battery charge

Place the handset on the base unit or

charger for about 7 hours before

initial use.

LWhile charging, “Charging” is

displayed and the charge indicator on

the handset lights up. When the

batteries are fully charged, “Charge

Completed” displays. The charge

indicator stays lit even after the

batteries are fully charged.

*1 Model shown is KX-TG7301.

*2 KX-TG7302/KX-TG7322

Note:

LIt is normal for the handset to feel

warm during charging.

LIf you want to use the unit

immediately, charge the batteries for

at least 15 minutes.

LClean the charge contacts of the

handset, base unit, and charger with a

soft, dry cloth once a month. Clean

more often if the unit is exposed to

grease, dust, or high humidity.

Rechargeable Ni-MH ONLY Base unit*1 Charger*2

Contents

Main Page Product information Notable differences between the models Accessory information Supplied accessories Additional/replacement accessories Expanding your phone system Handset (optional): KX-TGA731AZ For your safety WARNING CAUTION General notice Important safety instructions For best performance Page Controls Handset Display {^} {<}{>} Volume down {V} Connections Hook (220240 V AC, 50/60 Hz) To single-line telephone socket C A B Battery installation and replacement B (220240 V AC, 50/60 Hz) To single-line telephone socket DSL/ADSL filter 1 2 Rechargeable Ni-MH ONLY Battery charge Wall mounting Charger Symbols used in these operating instructions Turning the power on/off Setting up the unit before use Display language 3 Page Making calls 1 2 3 1 2 Useful features during a call Mute 1 2 Recall/flash For call waiting or Call Waiting Caller ID service users Key lock Handset phonebook Copying phonebook entries Programmable settings Programming by scrolling through the display menus 2 3 4 Page Special instructions for programmable settings Alarm 4 5 6 7 8 Registering a unit 5 2 3 4 5 6 7 Increasing the range of the 2 3 Using Caller ID service Caller ID features Caller list Answering system Memory capacity Turning the answering system on/off Using the base unit Using the handset Greeting message Listening to messages using the base unit Operating the answering system Erasing all messages Listening to messages using the handset 3 4 Operating the answering system Remote operation Remote commands Turning on the answering system remotely 1 2 Answering system settings Number of rings before the unit answers a call 4 5 Callers recording time 4 5 Call screening 4 Page Voice Mail Service Voice mail service Intercom/Locator Intercom Making an intercom call 1 2 3 Answering an intercom call 1 2 Transferring calls Conference calls 1 2 3 4 Character entry Character entry modes Characters available in each character entry mode Page Error messages Troubleshooting 2 3 Page Page Page Page Specifications Index Index Page Page PNQX1154ZA Attach your purchase receipt here.