Panasonic KX-TG7301NZ, KX-TG7302NZ Troubleshooting

Useful Information

43

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect

the base unit’s AC adaptor and turn off the handset, then reconnect the base unit’s

AC adaptor and turn on the handset.

General use

Problem Cause/solution

The unit does not work. LMake sure the batteries are installed correctly

(page 13).

LFully charge the batteries (page 14).

LCheck the connections (page 12).

LUnplug the base unit’s AC adaptor to reset the

unit and turn off the handset. Reconnect the

adaptor, turn on the handset and try again.

LThe handset has not been registered to the

base unit. Register the handset (page 26).

I cannot hear a dial tone. LThe base unit’s AC adaptor or telephone line

cord is not connected. Check the connections.

LIf you are using a splitter to connect the unit,

remove the splitter and connect the unit to the

wall socket directly. If the unit operates

properly, check the splitter.

LDisconnect the base unit from the telephone

line and connect the line to a known working

telephone. If the working telephone operates

properly, contact our service personnel to

have the unit repaired. If the working

telephone does not operate properly, contact

your service provider/telephone company.

I do not know how to erase y

(Missed call) from the display.

LThere are unviewed missed calls remaining.

View them using the following method.

1K (middle soft key)

2{V}/{^}:“Caller List”iM

3Press {V} to search from the most recent

call, or press {^} to search from the oldest

call.

Contents

Main Page Product information Notable differences between the models Accessory information Supplied accessories Additional/replacement accessories Expanding your phone system Handset (optional): KX-TGA731AZ For your safety WARNING CAUTION General notice Important safety instructions For best performance Page Controls Handset Display {^} {<}{>} Volume down {V} Connections Hook (220240 V AC, 50/60 Hz) To single-line telephone socket C A B Battery installation and replacement B (220240 V AC, 50/60 Hz) To single-line telephone socket DSL/ADSL filter 1 2 Rechargeable Ni-MH ONLY Battery charge Wall mounting Charger Symbols used in these operating instructions Turning the power on/off Setting up the unit before use Display language 3 Page Making calls 1 2 3 1 2 Useful features during a call Mute 1 2 Recall/flash For call waiting or Call Waiting Caller ID service users Key lock Handset phonebook Copying phonebook entries Programmable settings Programming by scrolling through the display menus 2 3 4 Page Special instructions for programmable settings Alarm 4 5 6 7 8 Registering a unit 5 2 3 4 5 6 7 Increasing the range of the 2 3 Using Caller ID service Caller ID features Caller list Answering system Memory capacity Turning the answering system on/off Using the base unit Using the handset Greeting message Listening to messages using the base unit Operating the answering system Erasing all messages Listening to messages using the handset 3 4 Operating the answering system Remote operation Remote commands Turning on the answering system remotely 1 2 Answering system settings Number of rings before the unit answers a call 4 5 Callers recording time 4 5 Call screening 4 Page Voice Mail Service Voice mail service Intercom/Locator Intercom Making an intercom call 1 2 3 Answering an intercom call 1 2 Transferring calls Conference calls 1 2 3 4 Character entry Character entry modes Characters available in each character entry mode Page Error messages Troubleshooting 2 3 Page Page Page Page Specifications Index Index Page Page PNQX1154ZA Attach your purchase receipt here.