Panasonic KX-TG7301NZ, KX-TG7302NZ - page 45

Useful Information

45

Making/answering calls, intercom

*1 KX-TG7321/KX-TG7322

Problem Cause/solution

w is flashing. LThe handset is not registered to the base unit. Register

it (page 26).

LThe handset is too far from the base unit. Move closer.

LThe base unit’s AC adaptor is not connected. Check

the connections.

LYou are using the handset or base unit in an area with

high electrical interference. Place the base unit and

use the handset away from sources of interference.

Noise is heard, sound

cuts in and out.

LYou are using the handset or base unit in an area with

high electrical interference. Place the base unit and

use the handset away from sources of interference.

LMove closer to the base unit.

LIf you use a DSL/ADSL (JetStream) service, we

recommend that you contact your DSL/ADSL service

provider to have a DSL/ADSL Splitter installed. We do

not recommend the use of generic DSL/ADSL filters.

Contact your DSL/ADSL service provider for details.

The handset does not

ring.

LThe ringer volume is turned off. Adjust ringer volume

(page 23).

The base unit does not

ring.*1

LThe ringer volume is turned off. Adjust ringer volume

(page 24).

I cannot make a call. LThe handset is too far from the base unit. Move closer

and try again.

LAnother unit is in use. Wait and try again later.

LAnswering system is being used.*1 Wait and try again

later.

LIf you are using a BT double adaptor to connect the

unit, remove the adaptor and connect the unit to the

phone wall socket directly. If the unit operates properly,

check or replace the adaptor.

LThe key lock feature is turned on. Turn it off (page 20).

LThe unit is not designed to be used with rotary/pulse

dialling services.

Contents

Main Page Product information Notable differences between the models Accessory information Supplied accessories Additional/replacement accessories Expanding your phone system Handset (optional): KX-TGA731AZ For your safety WARNING CAUTION General notice Important safety instructions For best performance Page Controls Handset Display {^} {<}{>} Volume down {V} Connections Hook (220240 V AC, 50/60 Hz) To single-line telephone socket C A B Battery installation and replacement B (220240 V AC, 50/60 Hz) To single-line telephone socket DSL/ADSL filter 1 2 Rechargeable Ni-MH ONLY Battery charge Wall mounting Charger Symbols used in these operating instructions Turning the power on/off Setting up the unit before use Display language 3 Page Making calls 1 2 3 1 2 Useful features during a call Mute 1 2 Recall/flash For call waiting or Call Waiting Caller ID service users Key lock Handset phonebook Copying phonebook entries Programmable settings Programming by scrolling through the display menus 2 3 4 Page Special instructions for programmable settings Alarm 4 5 6 7 8 Registering a unit 5 2 3 4 5 6 7 Increasing the range of the 2 3 Using Caller ID service Caller ID features Caller list Answering system Memory capacity Turning the answering system on/off Using the base unit Using the handset Greeting message Listening to messages using the base unit Operating the answering system Erasing all messages Listening to messages using the handset 3 4 Operating the answering system Remote operation Remote commands Turning on the answering system remotely 1 2 Answering system settings Number of rings before the unit answers a call 4 5 Callers recording time 4 5 Call screening 4 Page Voice Mail Service Voice mail service Intercom/Locator Intercom Making an intercom call 1 2 3 Answering an intercom call 1 2 Transferring calls Conference calls 1 2 3 4 Character entry Character entry modes Characters available in each character entry mode Page Error messages Troubleshooting 2 3 Page Page Page Page Specifications Index Index Page Page PNQX1154ZA Attach your purchase receipt here.