Programming
27
■KX-TG7321/KX-TG7322
Press and hold {x} for about 5
seconds, until the registration
tone sounds.
LIf all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
LThe next step should be
completed within 90 seconds.
5Handset:
Wait until “Enter Base PIN” is
displayed. i Enter the base unit
PIN (default: “0000”). iM
LIf you forget your PIN, contact
your nearest Panasonic service
centre.
LWhen the handset has been
registered successfully, w stops
flashing.
Note:
LWhen you purchase an additional
handset, refer to the additional
handset’s installation manual for
registration.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored in the
base unit. This allows the handset to end
its wireless connection with the system.
1K (middle soft key)
2{V}/{^}:“Base Unit Setup”i
M
3{3}{3}{5}
4{V}/{^}:“Deregistration”i
M
LThe numbers of all handsets
registered to the base unit are
displayed.
5Select the handset(s) you want to
cancel by pressing the desired
handset number. iM
LThe selected handset number(s)
flashes.
LTo cancel a selected handset
number, press the number again.
The number stops flashing.
6{V}/{^}:“Yes”iM
LA confirmation tone sounds as
each handset number
disappears.
LThe handset does not beep when
cancelling its own registration.
7{ih}
Increasing the range of the base unit
You can increase the signal range of the
base unit by using a DECT repeater.
Please use only the Panasonic DECT
repeater noted on page 5. Contact your
Panasonic dealer for details.
Important:
LBefore registering the repeater to this
base unit, you must turn the repeater
mode on.
LDo not use more than one repeater at
a time.
Setting the repeater mode
1K (middle soft key)
2{V}/{^}:“Base Unit Setup”i
M
3{V}/{^}:“Repeater Mode”i
M
4{V}/{^}: Select the desired setting.
iMi{ih}
Note:
LAfter turning the repeater mode on or
off, w flashes on the handset
momentarily. This is normal and the
handset can be used once w stops
flashing.