Trojan 30 Assembly, RH. Handle Brace, 1/4-20x 2 1/4” Hex Bolt, 1/4-20 Hex Nut LH. Handle Brace

ASSEMBLY

RH. Handle

Brace

1/4-20 x 2 1/4”

Hex Bolt

1. Remove components from carton and place spreader upside down on a padded surface. Install LH. & RH. handle braces to frame as shown using four (4) 1/4-20 x 2 1/4” hex bolts and nuts but do not tighten.

5/32 Dia x 2”

Cotter Pin

Drive Wheel

1/4-20

Hex Nut

LH. Handle

Brace

1/8 Dia x 1” Cotter Pin

Free Wheel

2. Install drive wheel onto right-hand end of axle (you can identify the drive wheel by the cotter pin hole drilled in the hub). Hub must face toward frame. Align the hole in the drive wheel hub and the hole in the axle. Secure drive wheel to axle with 5/32 dia x 2” cotter pin. Install the free wheel on the opposite end of axle. Insert 5/32 dia x 1” cotter pin in the hole near the end of axle to retain free wheel.

1/4-20 x 1 1/2” Hex Bolt

DOT Handle Tube

3. Turn spreader upright and install end of handle tube with DOT between handle braces as shown. Secure with (2) 1/4-20 x 1 1/2” hex bolts and nuts.

1/4-20 Hex Nut