Trojan 30 owner manual completed in step #5

			Control Knob &
Remove Caution
			Wire Assembly
Label
		Spring
	Thumb
	Release

1/4-20 x 2 1/4” Bolt & Washer

1/4-20 Hex

Nut & Washer

4. Feed control knob/wire through the T-handle until spring touches the round hole. CAUTION: Do Not Compress Spring At This Time. Feed wire through the square handle tube. Be sure wire passes above the bolts in the handle brace. Secure T-handle to the tube with (1) 1/4-20 x 2 1/4” hex bolts, (2) washers, and (1) hex nut in the holes. Remove caution label and push the thumb release toward the centre and push down knob and shutoff spring until knob latches.

CAUTION: Once knob is latched, do not move thumb release until you have

completed in step #5.

Wire Clip

5. Slide wire retaining clip onto wire as shown. Insert wire through hole shutoff plate. Slide wire retaining clip over shutoff plate and wire until the clip locks into place.

	Shutoff Plate
Wire

Handle Grips

Screen Clips	6. Install handle grips onto the handle
Screen	as shown. Soapy water will ease
	installation. (Do not use petroleum
	based products). Insert screen into
	hopper by sliding it under the screen
	clips.