Troy-Bilt 1030 manual Auger Belt, Drive Belt

A

Belt Cover

Self-Tapping

Self-Tapping Screw

Screw

B

Drive Belt	Engine
	Pulley

Auger Belt

Figure 14

Auger Belt

1.Tip the snow thrower up and forward, so that it rests on the housing. Remove the self-tapping screws from the frame cover underneath the snow thrower and move the frame cover away. See Figure 15.

Frame Cover

Figure 15

2.Turn the shoulder screw a half a turn and slide it out of the mounting bracket. See Figure 16.

3.Unhook spring to release tension on the auger belt. Remove old belt and replace with new belt, installing it on the pulley. See Figure 16.

	Auger
	Pulley
Shoulder
Screw
Mounting Bracket	Spring

Figure 16

4.Wrap auger belt around the auger pulley. See Figure 16.

5.Re-insert shoulder screw into the mounting bracket and tighten to secure.

6.Wrap auger belt behind the idler. Reattach the spring to the bolt where it was earlier secured.

7.Re-install frame cover and flip the snow thrower back to the operating position.

8.Wrap auger belt around the engine pulley.

9.Re-install belt cover with the self-tapping screws removed earlier.

Drive Belt

1.Push idler counter-clockwise and insert a Phillips head screwdriver in the hole on the idler as shown in Figure 17. This will release tension on drive belt.

Engine	Auger Belt
Pulley
Drive Belt
Idler

Figure 17

2.Pull drive belt out and away from the engine pulley to remove. See Figure 17.

3.Tip the snow thrower up and forward, so that it rests on the housing. Remove the self-tapping screws from frame cover underneath the snow thrower and move the frame cover away. Refer to Figure 15.

15