3
Setting
Up Your
Chipper
Shredder
Vacuum
IMPORTANT
This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasoline and oil as instructed in the separate engine manual before operat- ing your machine.
NOTE: All references in this manual to the left or right side of the chipper shredder vacuum is from the operating position only. Exceptions, if any, will be specified.
NOTE: The metal tab on the nozzle must depress the safety switch button attached to the front of the chip- per shredder vacuum or the engine will not start.
Nozzle | Chipper |
| Chute |
Bag
| Tamper |
| Plug |
Safety Glasses | Bottle of Oil |
Figure
A
B
C
Figure
Figure
IMPORTANT: This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasoline and oil as instructed in the separate engine manual before operating your machine.
Loose Parts In Carton
1.Following is the list of loose parts shipped with your equipment. Compare the parts with the illustration in Figure
a.Nozzle
b.Bag
c.Chipper Chute
d.Engine Oil (May be located in bag)
e.Safety Glasses
f.Tamper Plug (If Equipped)
NOTE: All references in this manual to the left or right side of the yard vacuum is from the operating position only. Exceptions, if any, will be specified.
Attaching The Nozzle
2.a. Remove three wing nuts from the front of the chipper shredder vacuum. See Figure
b.Place nozzle in position over three studs on unit.
c.Secure with wing nuts just removed. See Figure
NOTE: The metal tab on the nozzle must depress the safety switch button attached to the front of the chipper shredder vacuum or engine will not start. See Figure
Attaching The Chipper Chute
3.Loosen, but do not remove, the two hex bolts, flat washers, and flange nuts which are secured to the support bracket. See Figure