Changing Engine Oil
NOTE: Check the oil level before each use and after every five hours of operation to be sure the correct oil level is maintained. Refer to Checking Oil Level in the Operation Section
1.Drain fuel from the tank by running the engine until the fuel tank is empty. Be sure the fuel fill cap is secure.
2.Place a suitable oil collection container under the oil drain plug.
3.Remove the oil drain plug, Figure
Oil Plug
Figure
4.Tip the engine to drain oil into the container. Used oil must be disposed of at a proper collection center.
5.Reinstall the drain plug and tighten it securely.
6.Refill with the recommended oil and check the oil level, refer to Assembly &
7.Reinstall the oil filler cap/dipstick securely.
CAUTION: Thoroughly wash your hands with soap and water as soon as possible after handling
used oil.
NOTE: Please dispose of used motor oil in a manner that is friendly to the environment. Take it to a recyling center or other collection center.
Spark Plug
WARNING! DO NOT check for a spark with the spark plug removed. DO NOT crank the engine with the spark plug removed.
WARNING! If the engine has been running, the muffler will be very hot. Be careful not to touch the muffler.
To ensure proper engine operation, the spark plug must be properly gapped and free of deposits.
1.Remove the spark plug boot and use a spark plug wrench to remove the plug, Fig.
Spark Plug
Spark Plug Boot
Figure
2.Visually inspect the spark plug. Discard the spark plug if there is any apparent wear, or if the insulator is cracked or chipped. Clean the spark plug with a wire brush if it is to be reused.
3.Measure the plug gap with a feeler gauge. Correct as necessary by bending the side electrode, Fig.
Electrode
Figure
4.Check that the spark plug washer is in good condition and thread the spark plug in by hand to prevent cross- threading.
16Section 7— Engine Maintenance