6.Slip the drive belt off the pulley and between friction wheel and friction wheel disc. See Fig.
If the snow thrower fails to drive with the drive control engaged, and performing the drive control cable adjustment fails to correct the problem, the friction wheel may need to be replaced. Follow the instructions below. Examine the friction wheel for signs of wear or cracking and replace if necessary:
1.Allow the engine to run until it is out of fuel.
2.Place the shift lever in third Forward (F3) position.
3.Carefully pivot the snow thrower up and forward so that it rests on the auger housing.
4.Remove the frame cover from the underside of the snow thrower by removing four
Figure
7.Remove and replace belt in the reverse order.
NOTE: Engaging the drive control will ease reassembly of the belt.
Figure
Section 8 — Service |
| 23 |
| ||
|
|
|