Drive Control Cable Adjustment
Adjust the drive control cable if the yard vacuum does not self propel with the drive control engaged, or if the unit hesitates while the engine maintains the same speed after approximately 20 hours of use.
To move the
1.a. Push the right side of the control out of the right hole in the upper handle. See Figure 15A.
b.Pivot control down towards the lower handle.
c.Pivot straight up to remove it from the left hole in the upper handle. See Figure 15A.
2.There is now sufficient slack in the drive control cable to grasp the
IMPORTANT: Make sure to insert the
3.You may now carefully reinstall the drive control by performing the previous steps in the opposite order and manner of removal.
IMPORTANT: Once assembled and prior to restarting, make sure that the cable is properly adjusted. With the drive control disengaged, the unit should freely pull in reverse.
Removing The Flail Screen
If the discharge area becomes clogged, remove the flail screen and clean area as follows.
1.Stop the engine. Make certain the chipper/shredder vacuum has come to a complete stop.
2.Before unclogging the discharge chute, disconnect and ground the spark plug wire to retaining post.
3.Remove the vacuum bag or blower chute from the unit as instructed in the OPERATION section to obtain access to flail screen.
4.Remove the three self tapping screws securing the belt cover, and remove the belt cover. See Figure 16.
5.Remove self tapping screw on right side of unit that attaches to the flail screen. See Figure 17.
6.Remove hex screw on top of rear housing near mounting bracket and the flange lock nut that secures flail screen. See Figure 17.
7.Remove and clean the screen by scraping or washing with water. See Figure 18.
8.Reinstall the screen.
Figure 16
Figure 17
Figure 18
5
Maintaining
Your Yard
Vacuum
15
