Troy-Bilt 2620 Controls and Features, Forward, Reverse, Shift Lever, Ignition Key, Choke Control

Controls and Features 4

Drive Control

Gas Cap

Chute Assembly

Oil Fill

Clean Out

Tool

Augers

Shift Lever

Chute Directional Control

Auger Control

	Mu￿er	Recoil Starter
		Handle
	Primer
	Ignition
	Key
	Throttle
	Control
	Choke
	Control	Electric Start
Skid Shoe	Oil Drain	Button
		Electric Starter Outlet
	Figure 4-1

Snow thrower controls and features are described below and illustrated in Fig. 4-1.

Shift Lever

The shift lever is located in the right side of the handle panel and is used to determine ground speed and direction of travel.

Forward

There are six forward (F) speeds. Position one (1) is the slowest and position six (6) is the fastest.

Reverse

There are two reverse (R) speeds. One (1) is the slower and two (2) is the faster.

Choke Control

The choke control is found on the rear of the engine and is activated by rotating the knob clockwise. Activating the choke control closes the choke plate on the carburetor and aids in starting the engine.

Ignition Key

The ignition key is a safety device. It must be fully inserted in order for the engine to start. Remove the ignition key when the snow thrower is not in use.

Note: Do not turn the ignition key in an attempt to start the engine. Doing so may cause it to break.

11