Assembly & Set-Up

3

 

 

 

Contents of Carton

 

•

One Snow Thrower

•

Two Replacement Auger Shear Pins •

One Product Registration Card

•One Snow Thrower Operator’s

Manual

Assembly

Handle

1.Place the shift lever in the Forward-6 position

2.Observe the lower rear area of the snow thrower to be sure both cables are aligned with roller guides before pivoting the handle upward. See Fig. 3-1.

Figure 3-1

NOTE: Make certain the upper ends of each cable are seated properly in its bracket.

3.Secure the handle by tightening the plastic knob located on both the left and right sides of the handle. Remove and discard any rubber bands, if present. They are for packaging purposes only.

Chute Assembly

1.Remove wing nut and hex screw from chute control assembly and clevis pin and cotter pin from chute support bracket. Position the chute assembly (forward-facing) over the chute base. See Fig. 3-2.

2.Place chute assembly onto chute base and secure chute control assembly to chute support bracket with clevis pin and cotter pin removed earlier. See See Fig. 3-3.

Figure 3-2

Figure 3-3

7