Troy-Bilt 42051 Snow Throwing Patterns, The discharge chute stays the same direction, Operation

Section 4: Operation

WARNING

Do not use your hands or feet to dislodge snow from inside the collector (auger/impeller) housing or the dis- charge chute. Any contact with the moving parts will cause serious injury.

Stop the engine and remove the spark plug wire from the spark plug and use a long (at least 3-feet [100CM] long) wooden stick to unclog these areas.

SNOW THROWING PATTERNS

Use the snow clearing pattern shown in Figure 4-4 when snow can only be thrown to one side. Begin throwing snow closest to the side opposite where it can be thrown and direct the discharge away from that side. When turning the unit around after each pass, rotate the dis- charge chute as you proceed so snow continues to be thrown in the proper direction.

Use the snow clearing pattern shown in Figure 4-5 to throw snow to both sides. When turning the unit, rotate the dis- charge chute as necessary to throw snow in the proper direction.

As you turn, rotate the discharge chute so that the snow is always thrown in this direction.

➡

Figure 4-4

The discharge chute stays the same direction

except when turning. Snow is thrown to each side.

Figure 4-5

15