Section 5: Maintenance
WARNING
Before inspecting, cleaning or servicing the machine, shut off engine, wait for all moving parts to come to a complete stop, disconnect spark plug wire and move wire away from spark plug.
Failure to follow these instructions can result in serious personal injury or property damage.
TROUBLESHOOTING
TROUBLE |
| POSSIBLE PROBLEM |
| SOLUTION |
Engine won’t start | 1. Choke knob in incorrect position | 1. | Move choke knob to CHOKE position | |
| 2. | Engine throttle lever in incorrect start- | 2. | Move throttle lever to correct starting |
|
| ing position |
| position |
| 3. | Engine not primed enough (when cold) | 3. | Push primer button several more times |
| 4. | Engine primed too much (when cold) | 4. Put choke knob in RUN position, move | |
|
|
|
| throttle lever to idle position, attempt to |
|
|
|
| start engine, then proceed with normal |
|
|
|
| starting procedure. DO NOT |
| 5. | Spark plug wire disconnected | 5. | Connect spark plug wire |
| 6. | Fouled or faulty spark plug | 6. | Remove, clean, inspect, |
|
|
|
| replace spark plug |
| 7. | Gasoline tank empty | 7. | Fill gasoline tank |
| 8. | Fuel | 8. | Open fuel |
| 9. | Carburetor “varnished” from old gas | 9. | Contact authorized dealer |
|
|
|
| |
Engine difficult to start | 1. Incorrect choke knob setting | 1. | Put choke knob in correct setting | |
| 2. | Throttle lever in incorrect position | 2. | Move throttle lever into FAST position |
| 3. | Fuel | 3. | Open fuel |
| 4. | Engine not primed enough | 4. | Push primer button several more times |
| 5. | Stale gasoline in tank | 5. | Drain gasoline from tank, refill with |
|
|
|
| fresh gasoline |
| 6. | Fouled or faulty spark plug | 6. | Remove, clean, inspect, |
|
|
|
| replace spark plug |
Engine idles rough | 1. Faulty or fouled spark plug | 1. | Remove, clean, inspect, | |
|
|
|
| replace spark plug |
| 2. | Incorrect choke setting | 2. | After engine starts, gradually rotate |
|
|
|
| choke knob to RUN position |
|
|
|
| |
Engine overheats | 1. Dirty air screen | 1. | Remove all debris from air screen | |
| 2. | Low engine oil level | 2. | Check oil, add as necessary |
| 3. | Dirty cooling fins | 3. | Clean cooling fins |
| 4. | Loose spark plug | 4. | Tighten plug |
|
|
|
| |
Auger drive lever does not actuate | 1. Tension too low on spring at lower | 1. | Increase tension on spring | |
auger |
| end of auger drive control rod |
|
|
| 2. | Broken auger shear bolts | 2. | Replace auger shear bolts |
| 3. | Loose or broken spring | 3. | Replace spring |
| 4. | Auger frozen | 4. | Allow auger to thaw |
|
|
|
| (continued) |
|
|
|
|
|
21