Danby DAC050MB1GB manual Troubleshooting, Problem, Possible Cause, Solutions

Troubleshooting

Occasionally a problem may arise that is minor in nature, and a service call may not be neccessary. Use this trou- bleshooting guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby’s Toll Free Number 1-800-263-2629for assistance.

PROBLEM	POSSIBLE CAUSE	SOLUTIONS
PROBLEM	POSSIBLE CAUSE	SOLUTION
		• Check connection of power cord to power
		source.
1) Air conditioner will not	• No power to the unit.	• Check fuse or circuit breaker.
		• Set SELECTOR SWITCH to position other
operate.
		than “OFF”.
		• The power cord “RESET” button must always
		be pushed in (engaged) for correct operation.
	• Dirty air filter.	• Clean/replace air filter.
		• Check with dealer to determine proper unit
	• Unit size inappropriate for application.
	• Blocked air flow.	capacity for application.
2) Inefficient or no cooling.		• Remove obstruction from grill or outdoor
	• Power interruption, settings changed
		louvres.
	too quickly, or compressor overload
		• Turn the unit off and wait 5 minutes before
	tripped.
		attempting to restart.
3) Noisy unit.	• Loose parts.	• Tighten loose parts.
	• Inadequate support.	• Provide additional support to unit.
4) Odors.	• Formation of mold, mildew, or algae on	• Clean unit thoroughly.
	wet surfaces.	• Place algaecide tablet in base pan.
5) Water dripping outside.	• Hot and humid weather.	• Condensation run-off is normal under these
		conditions.
	• Unit is not properly angled to allow	• Unit must be installed on an angle for proper
6) Water dripping inside.	water to drain outside.	condensation run-off. Check the unit and
		make any adjustments.
		• When outdoor temperature is approximately
	• Low outside temperature.	18.3°C (65°F) or below, frost may form
7) Ice or frost build-up		when unit is in cooling mode. Switch unit to
	• Unit air filter is dirty.
		FAN (only) operation until frost melts.
		• Remove and clean filter.

NOTES:

1)If circuit breaker is tripped repeatedly, or fuse is blown more than once, contact a qualified technician.

2)When unit is installed using proper installation steps, unit is properly tipped toward the outdoors to allow for condensation run-off.

10