Operation | 5 |
| |
|
|
1. AttachWARNING!spark plug wireAlwaysto sparkkeepplughands. Makeandcertainfeet cleartheof metal loopmovingon thepartsend. Dofnottheusesparkpressurizplug wired(insidestartingthe rubberfluidboot). Vaporsis fastenaredflammablesecurely over. the metal tip on the spark plug.
2. Make certain both the auger control and drive control are NOTE: Allow the engine to warm up for a few minutes after
in the disengaged (released) position.
starting. The engine will not develop full power until it reaches 3. Move throttle control up to FAST position. Insert ignition operating temperatures.
key into slot. Make sure it snaps into place. Do not attempt
ElectrictoStarterturn the key.
NOTE: WARNING!The engine cannotThe electricsta unlessstartertheis equippedkey is insertedwith a into ignitiongroundedswitchthree.
designed to operate on 120 volt AC household
Electric Starter
current. It must be used with a properly grounded Determine
carefully prior to operating the electric starter. Warning! The optional electric starter is DO NOT use electric starter in rain.
equipped with a grounded
wiring, DO NOT use the electric starter under any
If you have a grounded
follows:
2. Insert ignition key fully into slot, Fig.
1. Plug the extension cord into the outlet located on the into place. DO NOT turn ignition key. The engine cannot engine’s surface. Plug the other end of extension cord start unless the key is inserted into ignition switch.
into a
Figure
ventilated area.
2.Rotate choke control to FULL choke position (for a cold engine start).
3.NOTE:Plug theIf theextensionengi ecordis alreadyinto thewarm,electricplaceoutletchokelocatedontrol in onthetheOFFengineposition.Pluginsteadheotherof FULLend. of extension cord into
a
3.Push the primer two or three times for cold engine start, ventilated area. See Fig.
making sure to cover vent hole in the center of the primer
Figure
4.Movewhen throttlepushingcontrol. to FAST (rabbit) position.
5.NOTE:Move chDokeNOTto useth ONprimerpositionto restart(coldaenginewarm enginestart). Ifafter a engineshort shutdownis warm,.place choke in OFF position.
64. | Push primstarter |
| vent hole when pushing. If engine is warm, push primer |
| NOTE: Do NOT Do NOT hold the button down for longer |
| only once. Always cover vent hole when pushing. Cool |
| than seven (7) seconds at a time. Doing so may damage |
| weather may require priming to be repeated. |
| your engine’s electric starter. |
7 | Push starter button to start engine. Once the engine |
4. | Once the engine starts, release starter button. |
5. | starts, immediately release starter button. Electric starter |
As the engine warms, slowly rotate the choke control to the | |
| is equipped with thermal overload protection; system will |
| OFF position. If the engine falters, quickly rotate the choke |
temporarily
8.As the engine warms, slowly rotate the choke control to OFF position. If the engine falters, restart engine and run with choke at
9.After engine is running, disconnect power cord from electric starter. When disconnecting, always unplug the end at the wall outlet before unplugging the opposite end from the engine.
13