Assembly & Set-Up

3

 

 

 

Contents of Carton

 

•

One Snow Thrower

•

Two Replacement Auger Shear Pins

•

One ChuteProductAssemblyR gistration Card

•

One Snow Thrower Operator’s

•

One ProductTecumsehRegistrationEngine Operator’sCard

•

One Product Registration Card

 

Manual

 

Manual

 

 

Assembly
Handle

1.PlaceObs rvethetheshiftlowerlever earintheareaforwardardF of the-snow-66positionthrower. to be sure both cables are aligned with roller guides before pivoting

2.Observe the lower rear area of the snow thrower to be sure the handle upward. See Fig. 3-1.

both cables are aligned with roller guides before pivoting NOTE:the handleMakeupwardcertain. Seeth upperFig.3-1ends. of each cable are seated properly in its bracket.

Figure 3-1

2.NOTE:SecureMakethehandlecertainbythetighteningupper endstheofplasticeachknobcablelocatedare onseatedbothproperlythe left andinitsrightbracketsides. of the handle. Remove

and discard any rubber bands, if present. They are for

3.2 Secure the handle by tightening the plastic knob located packaging purposes only.

on both the left and right sides of the handle. Remove

ChuteandAssemblydiscard any rubber bands, if present. They are for packaging purposes only.

1. Position the chute assembly over the base. See Fig. 3-2.

Chute Assembly

2. Close the flange keepers to secure the chute assembly

1.PositionRemoveto the chutthewingchutebasenut. andTheassemblyhexflangescrewoverk epersfromthebasewillchuteclick.SeecontrolintoFig. 3place-2. whassemblynproperlyand cleviscurepin.SeeandFigcotter.3-3.pin from chute support

2.Close the flange keepers to secure the chute assembly bracket. Position the chute assembly (forward-facing) over NOTE:to the chuteIf th flbasenge.Thek epersflangewillkeepersnot easilywill click into place, the chute base. See Fig. 3-2. whenuse theproperlypalm ofsecureyo hand.SeetoFigapply.3-3. swift, firm pressure to

2.thePlacebackchuteof eachassembly. onto chute base and secure chute NOTE: If the flange keepers will not easily click into place, control assembly to chute support bracket with clevis pin use the palm of your hand to apply swift, firm pressure to and cotter pin removed earlier. See See Fig. 3-3.

the back of each.

2 1

Figure 3-2

Figure 3-3