Chute Directional Control

The chute directional control is located on theleft leftsidesideof theof thesnow dashrowertThe chutepanel.Todirectional.change thecontroldirectionslocatedin whichonsnowleft sideis thrown,of the snowturn

tchrowerutedirectional.To changecontrolthe directionas follows:in which snow is thrown, turn

•

To change the direction in which snow is thrown, squeeze

chute directional control as follows:

•

the button on the joy-stick and pivot the joy-stick to the

Crank clockwise to discharge to the left.

•rightCrankorclockwiseto the ftto. discharge to the left.

•Crank counterclockwise to discharge to the right.

•ToCrankchangecounterclockwisethe angle/distanceto dischargewhich snowto theisrightthrown,. pivot Heatedthe joyGrips*-stick forward or backward.

Heated Grips*

To activate the heated grips (*on select models), move the switch

found on the rear of the dash panel into the ON position.

To activate the heated grips,(*onmoveselectthe switchmodels),foundmoveontheswitchrear foundof the dashonthepanelrear intoofthethedashON panelositionto. the ON position.

Chute Clean-Out Tool

Warning! Never use your hands to clear a clogged chutecloggassemblydchute.Shutassemblyoff engine.Shutandoffrenginemainbehindand remain handles untilbehindall movinghandlespartsuntilhaveallstoppedmovingbeforepartshaveuncloggingstopped.

before unclogging.

The chute clean-out tool is conveniently fastened to the rear of tTheaugerchutehousingclean-outwithtoolaismounticonvenientlygclip. Shouldfastenedsntowtheandreariceof becomethe augerlodgedhousing thewithchutea mountingassemblyclipduring.Shouldoperation,snow andproceedice asbecomef llowslodgedto safelyin thcleanchutthe assemblychuteassemblyduringandoperation,chute oproceedening:

as follows to safely clean the chute assembly and chute opening: 1. Release both the Auger Control and the Drive Control.

1.Release both the Auger Control and the Drive Control.

2.Stop the engine by removing the ignition key.

2.Stop the engine by removing the ignition key.

3.Remove the clean-out tool from the clip which secures it to

3.Removethe rear ofthethecleanauger-outhousingtool from. the clip which secures it to the rear of the auger housing.

4.Use the shovel-shaped end of the clean-out tool to

4.Usedislodgethe shoveland scoop-shapedanyendsnowof andthecleanicewhich-out toolhasformedto in dislodgeand near andthechutescoopassemblyany snow. and ice which has formed in and near the chute assembly.

5.Refasten the clean-out tool to the mounting clip on the

5.Refastenrear of thetheaugcleranhousing,-out toolreinsertto the mountingtheignitionclipkeyonandthe restartofthethesnowaugerthrower’shousing,engireinsert. the ignition key and

start the snow thrower’s engine.

While standing in the operator’s position (behind the snow Whilethrower),standingengageinttheaugeroperator’sc ntrolpositionfor a few(behindsecondsthe tosnowclear any thrower),remainingengagesnow andtheiceaugerfromcontrolthe chutefor aassemblyfew seconds. to clear any remaining snow and ice from the chute assembly.

12Section 4— Controls and Features