Auger Shaft

At least once a season, remove the shear pins from the auger shaft. Spray lubricant inside the shaft and around the spacers and the flange bearings found at either end of the shaft.

See Fig. 6-3.

Figure 6-3

Adjustments

ShiftC u eCableBracket Adjustment

If the fullspiralrangeat theofbottomspeeds (forwardofthe chuteanddirectionalreverse) cannotcontrolbeis not achieved,fully engagingreferwithtothethefigureschutetoassembly,the righttheandchuteadjustbracketthe shiftcan be cableadjustedas follows:.To do so:

1.PlaceLoosenthetheshifttwolevernutsinwtheichfastestsecureforwardthe chutespeedbracketpositionand. reposition it slightly. See Fig. 6-4.

2.Loosen the hex nut on the shift cable index bracket. See

2.FigRetighten.6-4. the nuts.

Figure 6-4

Auger3. PivotControlthe bracket downward to take up slack in the cable. Refer4. toRetightenhe Assemblythe hexandnutSet.-up section for instructions on

adjusting the auger control cable.

Auger Control

Chute Assembly

Refer to the Assembly and Set-up section for instructions on adjustingRefer to thetheAssemblyauger controland Setcable-up.section for instructions on

adjusting the skid shoes chute assembly.

Chute Assembly

Skid Shoes

Refer to the Assembly and Set-up section for instructions on adjustingRefer to thetheAskidsemblyshoesandchuteSet-upassemblysection. for instructions on

adjusting the skid shoes.

Skid Shoes

Refer to the Assembly and Set-up section for instructions on adjusting the skid shoes.

16Section 6— Maintenance & Adjustments