Section 2: Assembly
Remove the temporary screw (J, Figure
NOTE: Do not bend or over stretch the spring while installing.
6.Pull the Wheels/Tines/PTO Lever back to align the forward most holes (Q, Figure
Securely tighten all other hardware (Q, R, Figure
(S) is properly seated at both ends.
Completed assembly should appear as illustrated in Figure
7.Test the operation of the Wheels/Tines/PTO Lever. Push the lever down until it engages in the Forward position. The clutch roller (T, Figure 2- 10) must rest beneath the adjustment block (U). Next, move the lever up to the Neutral position. The clutch roller (T, Figure
S |
R |
Q |
P |
Figure
T
C | G |
H | D |
F | B |
E | A |
| I |
Figure
U
Figure
(T)rests under the adjustment block (U).
T
U
Figure
K
J | L |
Figure
N |
M |
Figure
(T)rests against middle area of the adjustment block (U).
STEP 6: Check Gear Oil Levels
Your tiller has two separate transmis- sions: one for the Power Unit (Figure 2- 12), the other for the Tine Attachment (Figure
8