Troubleshooting

8

 

 

 

Problem

 

Cause

 

Remedy

 

 

 

 

 

 

 

 

 

 

Engine does not start

1.

Wheels/Tines/PTO Drive Lever not in Neutral

1.

Put Wheels/Tines/PTO Drive Lever in Neutral

 

 

position

 

 

 

2.

Fuel tank low or empty.

2.

Add Fuel

 

3.

Fuel line restricted or clogged.

3.

Contact authorized sevice dealer

 

4.

Choke control improperly set.

4.

See Engine Operator’s Manual

 

5.

Water or dirt in fuel, and /or fuel system.

5.

Drain Fuel and fresh fuel

 

6.

Spark plug fouled or worn, loose or

6.

Inspect spark plug, replace if neccessary

 

 

damaged.

 

 

 

7.

Carburetor out of adjustment.

7.

See Engine Operator’s Manual

 

8.

Air filter clogged with oil or dirt.

8.

See Engine Operator’s Manual

 

9.

Carburetor float faulty or float valve leaking

9.

Tap side of bowl lightly with handle of

 

 

 

 

screwdriver or similar object.

 

10. Stale fuel clogs carburetor, and valves.

10. Drain old fuel and add new fuel.

 

11. Fuel tank shut-off valve (if equipped) not in

11. Open the valve up completely

 

 

fully Open position.

 

 

 

12. Electrical connections loose or shorted to

12. Contact authorized service dealer

 

 

metal frames, brackets or covers (Electric

 

 

 

 

Start tillers only)

 

 

 

13. Battery discharged (Electric Start tillers only)

13. Charge battery

 

14. Electric starter motor faulty (if equipped)

14. Contact authorized service dealer

 

 

 

 

 

Engine runs poorly or

1.

Broken flywheel fins (under engine shroud)

1.

Contact authorized service dealer

overheats

2.

Water or dirt in gasoline or carburetor.

2.

Contact authorized service dealer

 

 

3.

Carburetor out of adjustment

3.

Contact authorized service dealer

 

4.

Defective or incorrectly gapped spark plug.

4.

Inspect spark plug (see Engine Operator’s

 

 

 

 

Manual)

 

5.

Loose or cracked carburetor.

5.

See Engine Operator’s Manual

 

6.

Governor linkage not adjusted properly or

6.

Contact authorized service dealer

 

 

binding.

 

 

 

7.

Check pan gasket, engine seals and drain

7.

Contact authorized service dealer

 

 

plugs for leaks.

 

 

 

 

 

 

 

Engine runs well, but labors

1.

Governor linkage too tight

1.

Contact authorized service dealer

under tillers load

2.

Carburetor or throttle out of adjustment

2.

See Engine Operator’s Manual

 

 

3.

Tilling depth too deep

3.

Adjust tilling depth

 

4.

Worn tiller worm gear or loose drive shaft

4.

Contact authorized service dealer

 

 

 

 

 

Engine shuts off when

1.

Short in key switch or key switch wire

1.

Contact authorized service dealer

Wheels/Tines/PTO Drive

2.

Starter motor mounting bolts loose

2.

Contact authorized service dealer

Lever is in forward

 

 

 

 

 

3.

Oil level low

3.

See Engine Operator’s Manual for

 

 

 

 

instructions on adding oil

 

 

 

 

 

40