6.Pull the Wheels/Tines/PTO Lever back to align the forward most holes in the yoke plate with the holes in the lever plates. Also align the bushing that is inside the short link bar. Install the screw, star washer, and nut, then tighten securely. Securely tighten all other hardware. Also ensure that the spring is properly seated at both ends. Completed assembly should appear as illustrated in Fig. 3-10.

Clutch Pawl Spring

8.To test Reverse, lift and hold the lever all the way up in the Reverse position, then let it go. The lever should automatically return to the Neutral position. See Fig.

3-12. If not, do not use the tiller. See your local authorized dealer or call the Factory Technical Service Department for instructions.

Forward Hole

Short Link Bar

Figure 3-10

7.Test the operation of the Wheels/Tines/PTO Lever. Push the lever down until it engages in the Forward position. The clutch roller must rest beneath the adjustment block. Next, move the lever up to the Neutral position. See Fig. 3-11.

Adjustment Block

Clutch Roller

Figure 3-11

Clutch Roller

Adjustment Block

Figure 3-12

Section 2 — Assembly & Set-Up