Assembly & Set-Up

3

 

 

 

Contents of Carton

 

•

One Snow Thrower

•

One 20 oz. Bottle 5W-30 Oil

•

Two Ignition Keys

•

One Chute Assembly

•

One Chute Rotation Control (If equip.)

•

One Set of Drift Cutters (If equip.)

•

One Electric Starter Cord (If equip.)

•

One Snow Thrower Operator’s Manual

•

One Engine Operator’s Manual

NOTE: This Operator’s Manual covers several models. Snow thrower features may vary by model. Not all features in this manual are applicable to all snow thrower models and the snow thrower depicted may differ from yours.

NOTE: All references to the left or right side of the snow thrower are from the operator’s position. Any exceptions will be noted.

Tools Required

•• One 5/16-inch wrench (or adjustable wrench)

•• One 1/2-inch wrench (or adjustable wrench)

Assembly

Positioning the Upper Handle

1.Remove the wing knob and carriage bolt from the top of the lower handle. See Figure 3-1. It is not necessary to remove the shoulder screw and flange lock nut below the wing knob and carriage bolt.

2.Pivot the upper handle into the operating position. Be sure not to pinch any of the cables in the process. See Figure 3-2.

Wing Knob

Carriage Bolts

Wing Knob

Figure 3-2

Installing the Chute

1.Remove the hex washer screws in the chute base. See Figure 3-3.

Figure 3-1

Figure 3-3

7