2.Align the holes in the chute base with the holes in the lower chute and secure with the previously removed hex washer screws. See Figure
Figure
Installing the Chute Rotation Control (If so equipped)
To install the chute rotation control (only models so equipped) proceed as follows:
1.Remove the hex lock nut and machine screw from the chute rotation control. See Figure
1
Chute Rotation Control
Hex Lock |
| |
Nut | Machine Screw | 2 |
|
| |
|
| Hex Lock |
|
| Nut |
| Chute Control Rod | |
|
| Machine Screw |
Figure
2.Place the chute rotation control onto the chute rotation rod and secure with the hex lock nut and machine screw removed in step 1. See Figure
1.Remove the carriage bolts and flange lock nuts from the drift cutters.
2.Install the drift cutters and secure with the carriage bolts and flange lock nuts removed in step 1. See Figure
Drift Cutter
Flange Lock Nut
Carriage Bolt
Figure
1.Remove the eye bolt and handle knob from the manual bag.
2.Place the eye bolt and handle knob on the upper handle as shown in Figure
Eye Bolt
Recoil Starter
Handle
A Handle
Knob
B
Figure
NOTE: The opening of the eye bolt should face toward the back of the snow thrower.
8Section 3— Assembly &