TROUBLE SHOOTING
PROBLEM | POSSIBLE CAUSE(S) | CORRECTIVE ACTION | ||
|
|
|
|
|
Engine fails to start | 1. | Blade control handle disen- | 1. | Engage blade control handle. |
|
| gaged. |
|
|
| 2. | Spark plug wire disconnected. | 2. | Connect spark plug wire. |
| 3. | Fuel tank empty, or stale fuel. | 3. | Fill tank with clean, fresh gasoline. |
| 4. | Blocked fuel line. | 4. | Clean the fuel line. |
| 5. | Faulty spark plug. | 5. | Clean, adjust gap or replace. |
| 6. | Engine flooded. | 6. | Wait a few minutes to restart, but |
|
|
|
| do not prime. |
Engine runs erratic | 1. | Spark plug wire loose. | 1. | Connect and tighten spark plug wire. |
| 2. | Blocked fuel line or stale fuel. | 2. | Clean the fuel line; fill the tank |
|
|
|
| with clean, fresh gasoline. |
| 3. | Vent in gas plugged. | 3. | Clear vent. |
| 4. | Water or dirt in fuel system. | 4. | Drain the fuel tank and carbure- |
|
|
|
| tor. Refill with fresh fuel. |
| 5. | Dirty air cleaner. | 5. | Clean air cleaner. |
| 6. | Carburetor out of adjustment. | 6. | Adjust carburetor. |
Engine overheats | 1. | Engine oil level low. | 1. | Fill crankcase with proper oil. |
| 2. | Air flow restricted. | 2. | Remove blower housing and |
|
|
|
| clean. |
| 3. | Carburetor not adjusted prop- | 3. | Adjust carburetor. |
|
| erly. |
|
|
Idles poorly | 1. | Spark plug fouled, faulty or gap | 1. | Reset gap to .030" or replace |
|
| too wide. |
| spark plug. |
| 2. | Carburetor improperly adjusted. | 2. Adjust carburetor. | |
| 3. | Dirty air cleaner. | 3. | Clean air cleaner. |
Excessive vibration | 1. | Cutting blade loose or unbal- | 1. | Tighten blade and adapter. Bal- |
|
| anced. |
| ance blade. |
| 2. | Bent cutting blade. | 2. | Replace blade. |
Mower will not mulch grass | 1. | Wet grass. | 1. | Do not mow when gras is set; |
|
|
|
| wait until later to cut. |
| 2. | Excessively high grass. | 2. | Mow once at a high cutting |
|
|
|
| height, then mow again at de- |
|
|
|
| sired height or make a narrower |
|
|
|
| cutting path. |
| 3. | Dull blade. | 3. | Sharpen or replace blade. |
Uneven cut | 1. | Wheels not positioned correctly. | 1. | Place all four wheels in same |
|
|
|
| hight position. |
| 2. | Dull blade. | 2. | Sharpen or replace blade. |
Wheels will not propel | 1. | Belt not installed properly. | 1. | Check belt for proper pulley in- |
|
|
|
| stallation and movement. |
| 2. | Debris clogging drive operation. | 2. Clean out debris. | |
NOTE: For repairs beyond the minor adjustments listed above, contract your nearest authorized
service dealer.
15
