Troy-Bilt TB2000 manual Installing a Prewound Reel, Pawl Replacement

Maintenance (continued)

Slotted

Hole

Fig. 6-4

Fig. 6-5

Holding

Slot

Holding

Slot

Fig. 6-6

Eyelet

Eyelet

Fig. 6-7

12.Insert the ends of the line into the two holding slots (Fig. 6-6). Leave about 4 inches (102 mm) of line beyond the holding slots.

13.Insert the ends of the line through the eyelets in the outer spool and place inner reel inside the outer spool (Fig. 6-7).

14.While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the inner reel.

15.Push the bottom cover into the outer spool until it snaps into place

INSTALLING A PREWOUND REEL

1.Press the tabs in and remove the bottom cover (Fig. 6-1).

2.Remove the old inner reel from the outer spool (Fig. 6-1).

3.Take the prewound inner reel and Insert the ends of the line through the eyelets in the outer spool (Fig. 6-7).

4.While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the inner reel.

5.Push the bottom cover into the outer spool until it snaps into place

Replacement Parts:

See Accessories / Replacement Parts on page 18.

PAWL REPLACEMENT

If the pawl in the cutting attachment requires replace- ment due to cracking or wear, use the following instructions.

1.Position the pawl so that it is hooked by the spring (Fig. 6-8).

2.Position a medium sized flat bladed screwdriver through the tab hole in the outer spool and under the pawl as shown in figure 6-8. The end of the screw- driver needs to be right next to the pawl shaft.

3.Turn the screwdriver to remove the pawl from it’s retaining hole in the outer spool.

4.Replace with a new pawl. Press the pawl in firmly until it snaps into place.

Position Pawl	Pawl Shaft
Tab Hole
Fig. 6-8	Screwdriver
	15