ASSEMBLY INSTRUCTIONS
WARNING: Be sure unit is
unplugged when making any adjustment.
NOTE: The assembly required for your trimmer is to install the debris shield, the assist handle and 2 divided shafts.
ASSEMBLY OF 2 SHAFTS
1.Remove and discard the rubber grommet ( packing material ) before assembling upper and lower shafts. ( Fig.1)
INSTALLATION OF ASSIST HANDLE
1.Remove nut and bolt from handle before assembly.
2.Place the assist handle on the upper shaft (some force is required) Fig 3.
3.Tighten the adjustment knob and bolt. (Fig. 4.)
Fig. 1
2.Align 2 arrows on upper and lower shaft as shown in Fig.2.
Fig.2
3.While pushing up on the shaft length adjustment button (A), slide upper shaft over lower shaft until it locks in place.
The shafts will not come back apart. NOTE: Once the upper and lower shafts are assembled, they will not separate again.
Fig. 3
Fig. 4
10