ADJUSTMENT INSTRUCTIONS
WARNING: Be sure unit is
unplugged when making any adjustment.
ADJUST SHAFT LENGTH
1.Grip shaft firmly.
2.Push shaft length adjustment button (B) and move upper shaft up or down to desired length. (Fig. 7)
NOTE: Shaft may be adjusted in trimming or edging mode.
Fig. 7
EDGING CONVERSION
1.Grip shaft firmly.
2.Press the edging conversion button (C) (Fig. 8) and rotate the handle assembly until it locks in place. (Fig. 9 normal trimmer mode & Fig. 10 edging mode)
Fig. 9 ( normal trimmer mode)
Fig. 10 (edging mode)
ADJUST THE ASSIST HANDLE
1.Loosen adjustment knob and move handle to a comfortable position on the upper shaft.
2.Tighten adjustment knob securely.
ADJUST THE TRIMMER SHAFT ANGLE
1.Squeeze the adjustment buttons (D) at the bottom of the shaft. (Fig. 11)
Fig. 11
Fig. 82. There are 4 settings to allow you to angle the shaft as needed to reach under decks, bushes etc.
12